“ALARM:2” : _(“G-code motion target exceeds machine travel. Machine position is likely lost due to sudden and immediate halt. “error:38” : _(“An invalid tool number sent to the parser”), “error:37” : _(“The G43.1 dynamic tool length offset command cannot apply an offset to an axis other than its configured axis. “error:36” : _(“There are unused, leftover G-code words that aren’t used by any command in the block.”), “error:35” : _(“A G2 or G3 arc, traced with the offset definition, is missing the IJK offset word in the selected plane to trace the arc.”), Try either breaking up the arc into semi-circles or quadrants, or redefine them with the arc offset definition.”), “error:34” : _(“A G2 or G3 arc, traced with the radius definition, had a mathematical error when computing the arc geometry. G2, G3, and G38.2 generates this error, if the arc is impossible to generate or if the probe target is the current position.”), “error:33” : _(“The motion command has an invalid target. “error:32” : _(“A G2 or G3 arc was commanded but there are no XYZ axis words in the selected plane to trace the arc.”), “error:31” : _(“There are unused axis words in the block and G80 motion mode cancel is active.”), “error:30” : _(“The G53 G-code command requires either a G0 seek or G1 feed motion mode to be active. “error:29” : _(“Grbl supports six work coordinate systems G54-G59. “error:28” : _(“A G-code command was sent, but is missing some required P or L value words in the line.”), “error:27” : _(“N line number value is not within the valid range of 1 – 9,999,999.”), “error:26” : _(“A G-code command implicitly or explicitly requires XYZ axis words in the block, but none were detected.”), “error:25” : _(“A G-code word was repeated in the block.”), “error:24” : _(“Two G-code commands that both require the use of the XYZ axis words were detected in the block.”), “error:23” : _(“G-code command in block requires an integer value.”), “error:22” : _(“Feed rate has not yet been set or is undefined.”),
“error:21” : _(“More than one g-code command from same modal group found in block.”), “error:20” : _(“Unsupported or invalid g-code command found in block.”), “error:16” : _(“Jog command with no ‘=’ or contains prohibited g-code.”), “error:15” : _(“Jog target exceeds machine travel.
“error:14” : _(“(Grbl-Mega Only) Build info or startup line exceeded EEPROM line length limit.”), “error:13” : _(“Safety door detected as opened and door state initiated.”), “error:12” : _(“(Compile Option) Grbl ‘$’ setting value exceeds the maximum step rate supported.”),
“error:11” : _(“Max characters per line exceeded. “error:10” : _(“Soft limits cannot be enabled without homing also enabled.”), “error:9” : _(“G-code locked out during alarm or jog state”), Ensures smooth operation during a job.”), “error:8” : _(“Grbl ‘$’ command cannot be used unless Grbl is IDLE. “error:6” : _(“Minimum step pulse time must be greater than 3usec”), “error:5” : _(“Homing cycle is not enabled via settings.”), “error:4” : _(“Negative value received for an expected positive value.”), “error:3” : _(“Grbl ‘$’ system command was not recognized or supported.”), “error:2” : _(“Numeric value format is not valid or missing an expected value.”), “error:1” : _(“G-code words consist of a letter and a value.
0 kommentar(er)
